Shades — with the light off
Always switch the fitting off and let the bulb cool before wiping the shade. Glass shades can be removed and washed if the instructions allow it, and then dried thoroughly.
An independent magazine about home lighting. We do not sell light fittings or do electrical work; we are not connected with the former site on this domain and have nothing to do with gambling.
Care
Dust on a shade quietly eats up some of the light, and a cracked cord on a desk lamp can cause trouble. Looking after your fittings takes little time if you do it regularly. We have gathered simple rules that help your lighting stay bright and your home stay safe.
A clean shade shines noticeably brighter than a dusty one. Sometimes, to make a room lighter, it is enough just to wipe the glass.
This advice covers care of the outside of a fitting. If the body needs taking apart or the lampholder or cable needs replacing, contact an electrician or a repair workshop.
Six habits that extend the life of light fittings.
Always switch the fitting off and let the bulb cool before wiping the shade. Glass shades can be removed and washed if the instructions allow it, and then dried thoroughly.
Clean fabric lampshades with a soft brush or a vacuum cleaner with an upholstery attachment. Wet cleaning is acceptable only if the manufacturer allows it.
From time to time, inspect the cords of desk lamps and floor lamps for cracks, kinks or exposed sections. Unplug a damaged fitting and do not use it until it has been repaired.
Change the bulb with the light switched off, hold it by the glass or body and screw it in without force. The new bulb must have the same cap and must not exceed the permitted wattage.
Lighting over the worktop quickly gets a greasy film. Wipe it regularly with the light off, using a slightly damp cloth, and do not let water get inside.
Make sure shades are firmly fixed and water does not collect on the body. If condensation or rust appears inside a shade, show the fitting to an electrician.
How to match a bulb to a fitting, how to judge your lighting in the evening and when you need an electrician.
What helps when planning lighting: a tape measure, a paper plan, a light meter app on your phone, a stepladder.
Bulbs, shades, lampshades and diffusers in general terms: how they differ and what to look for. The catalogue of articles is here too.
Information about lighting is given in general terms, based on the code of practice on natural and artificial lighting, lighting manufacturers’ instructions and the magazine’s editorial materials. The permitted lamp wattage, cap type and installation conditions for a particular fitting are set by its manufacturer: before changing a bulb, check the markings on the fitting and the instructions.