Guides
Guides to light at home
Much of lighting you can handle yourself: choosing a suitable bulb, moving a floor lamp, checking whether the armchair is comfortable for reading. Other things only with an electrician. Here are two short guides for jobs around the home and an honest account of where the line lies.
The right bulb starts with the markings on the fitting, not with the box on the shop shelf.
The guides describe actions that do not involve touching the electrical wiring. Anything to do with cables inside walls, the consumer unit, sockets or connecting a fitting to the mains is done by an electrician.
How to match a bulb to a fitting
Switch off and let the bulb cool
Before removing the old bulb, switch the fitting off at the switch, and unplug a desk lamp or floor lamp from the socket. Wait until the bulb has cooled so you do not burn your fingers.
Find the markings
On the body of the fitting, on the lampholder or in the instructions, the manufacturer gives the cap type and the maximum permitted bulb wattage. Take a photo of these markings on your phone.
Choose the cap
A cap can be a screw type, large or small, or a pin type. The new bulb must have exactly the cap specified for the fitting: adapters and attempts to screw in an unsuitable bulb are unsafe.
Do not exceed the permitted wattage
The wattage of the new bulb must not be higher than the wattage allowed for the fitting. An LED bulb uses noticeably less power for the same brightness, so it usually stays within the limit easily.
Choose the tint and shape
Decide whether you need warm or neutral light, and check that the bulb fits under the shade or lampshade. If the fitting is on a dimmer, the bulb must support dimming — this is stated on the packaging.
Screw in the bulb and check
Screw the bulb in without force, holding it by the glass or body, not by the cable. Switch on and make sure the bulb does not flicker or hum; if it does, remove it and find out why.
Dispose of the old bulb
Old bulbs should not go in the general rubbish if their packaging states special disposal rules. Find out where bulbs are collected in your area and take them there.
How to judge your lighting in the evening
Wait until dark
During the day artificial light mixes with daylight and is hard to judge. Do the check in the evening with the curtains drawn.
Walk around the room
Switch on the general light and follow your usual route: from the door to the window, to the sofa, to your workspace. Note dark corners and places where you cast a shadow on what you are doing.
Sit in your usual spots
Sit in the armchair, at the table, on the bed. Check for glare on the screen or the book, and whether light shines straight into your eyes from under a lampshade.
Check the colours
Look at fabric, wood and food in the kitchen. If colours look grey or unnatural, the bulb may have poor colour rendering or too cool a tint.
Write down your conclusions
Make a short list: what to move, where to add a lamp, where to change the tint. Check again after a few days — it takes time to get used to light.
Read also
- Care
How to wipe shades, change bulbs and spot damaged cords so your lighting lasts a long time.
- Materials
Bulbs, shades, lampshades and diffusers in general terms: how they differ and what to look for. The catalogue of articles is here too.
- Tools
What helps when planning lighting: a tape measure, a paper plan, a light meter app on your phone, a stepladder.
Sources
- Lighting manufacturers’ instructions (in general terms)
- The magazine’s editorial materials
Information about lighting is given in general terms, based on the code of practice on natural and artificial lighting, lighting manufacturers’ instructions and the magazine’s editorial materials. The permitted lamp wattage, cap type and installation conditions for a particular fitting are set by its manufacturer: before changing a bulb, check the markings on the fitting and the instructions.